Desengrasante de GYEON

Paint Preparation and Degreasing Before Ceramic Coating with GYEON Q²M

What is paint degreasing before coating? Degreasing with GYEON Q²M products removes polishing oils, silicone residues, and grease films from the paint – an indispensable final step before applying any GYEON Q² ceramic coating to ensure maximum adhesion and uniform cross-linking.

GYEON degreasing products from the Q²M line are the final cleaning step before ceramic coating. Even freshly polished paint carries invisible residues: polishing oils, lubricants, fingerprints, and silicone traces. These residues prevent uniform cross-linking of the coating with the clear coat – resulting in adhesion weaknesses, patchy coatings, or premature detachment. An IPA-based degreaser like GYEON Q²M Prep dissolves these contaminants and leaves an absolutely clean, adhesive surface. This step only takes a few minutes but significantly determines the quality of the coating result.

• Mandatory before every coating application. Without degreasing, there is no reliable coating adhesion. GYEON recommends an IPA wipe as a standard final step before every Q² product.
• Residue-free and fast-drying. IPA-based degreasers evaporate without leaving residues and create an absolutely clean surface without damaging the paint.
• Easy application. Spray onto a microfiber cloth, wipe evenly over the surface – done. No polishing, no waiting.

Practical tip from Detailing1: Always work panel by panel when doing an IPA wipe – not the entire vehicle at once. The degreaser evaporates quickly; if you work on too large areas at once, it will evaporate before you can wipe it off. Use two separate cloths for degreasing: one for application, one for removing residues.

GYEON Q²M Prep: How it Works and Its Use in the Coating Workflow

GYEON Q²M Prep is an IPA-based (Isopropanol) degreaser used after paint correction and before coating application. IPA dissolves organic residues – greases, oils, waxes, and silicones – and evaporates without leaving any residue. In the direct coating workflow, this looks like: Pre-wash → Decontamination → Polishing (if necessary) → IPA wipe → Coating application. Skipping this step risks inconsistencies in the coating layer. This is particularly critical with professional-grade coatings like Q² Syncro, which are very sensitive to surface contamination.

Buy Degreaser: GYEON Q²M Prep and IPA Products at Detailing1

At Detailing1, you will find GYEON Q²M degreasing products as an essential part of the Q² coating workflow. Combine with Q²M Polishing products for the complete paint preparation workflow.